Engine and Transmission

9pc Pick and Hook Set with Gasket ScraperHeavy DutyIdeal for Gasket Scraping / Hose Removal etc.

2pcs Carbide Scraper Set With Tungsten Carbide Tips for use on brake caliper and back plate sliding faces, exhaust manifolds, cylinder heads, gaske...

A bolt-on crankshaft pulley holding tool for blocking the pulley when loosening and tightening the pulley screw.Designed specifically for the Renau...

6pc Pick and Hook SetExtra Long Combination Pick and HookStraight Pick90 degree PickDouble Angle PickComplex Pick

Glow Plug Removal Master KitFor removing damaged and broken glow plugs from cylinder headsRemoves 8mm & 10mm glow plugsIncludes -Ratchet T-bar3...

Special designed for trucks with single or double disc clutches to provide a perfect fit to the spine of the clutch disc.Centre sleeve for pilot be...

Exhaust Hanger Pliersfor removing the Rubber Grommets from exhaust mountsFits a wide range of vehicles and modelsSaves time and energy.Long rubber ...

JLR Crankshaft Pulley Tool SetCrankshaft Pulley removal and holding tool.The Crankshaft Pulley needs to be removed for engine servicing.Applicable ...

3-Leg Fuel Tank Sender WrenchRange - 89 - 170mm DiameterUse with a 15mm Spanner or SocketFor removing and re-fitting Tank Sender Mounting Collars /...

6PC SAS Clutch Centering Alignment Tool For BMW ●SAC clutch mandrel kit for centring the clutch disc on the flywheel while installing the self adju...

Wide Application – For most diesel applications, brushes are specially engineered to fit injector seats.Great Function – Used to remove rust, carbo...

25pc Spark Plug Thread Repair KitComprehensive and time saving kit for spark plug thread repair.Especially suitable for the repair of deep-seated p...

Heavy Duty Nut Splitterwith 3 - 24mm Jaw C-FrameSmooth Action cracks nuts without damaging bolt threadsChisel Rotates to line up parallel to boltAd...

Injector Removal Extraction Tool KitDesigned to remove the injectors on Renault Trafic 2.0 DCI M9R Diesel Engines.Also used in the Nissan vehicles ...

Brake or Clutch Bleeding SystemOne-man bleeding system requiring no external power source.Reservoir holds 2.5 litres of hydraulic fluid -flush enti...

Universal Injector Seat Cleaning SetFor cleaning diesel injector seats prior to fitting new injectors.Silicone Nylon brushes 15 and 20mm.Steel wire...

Fuel Injector Gasket / Seal PullerFor the extraction of fuel injector copper washers.Slim shaft with threaded conical tip and slide hammer.

Flat Belt Tension Spanner SetFor BMW / Mini engines EP3 / EP6 / N12 / N14 / N16 and N18For releasing the tension when removing and installing the s...

Exhaust Clamp Pliers300mm Long with 60mm Jaw CapacitySuitable for Citroen / Peugeot / Renault vehicles

Swivel Head Oxygen Sensor Wrench7/8in. / 22mm

Working diameter: 81-83mmShaft diameter: 7.8 mmMax. drive speed: 300 rpm

5pc Oxygen Sensor and Thread Chaser SetSuitable for oxygen sensors found on most modern vehicles.Slotted sockets to allow for wiring harness.With 2...

Exhaust Spring Clamp Removal ToolLength : 150mm / 6in.Use with a 17mm SpannerFor early VW vehicles : Golf | Jetta | Passat

Exhaust Pipe Cutter / Tube Cutter with Ratchet A pipe or tube cutter, specifically designed as an exhaust pipe cutter with a ratchet mechanism, is ...

Exhaust and Tailpipe CutterCutting Capacity : 75mm diameterSuitable for cutting thin-wall tubing up to 2.5mm thick.Designed to enable access where ...

3pc Diesel Injector Bore & Sleeve Cleaning KitLong Spiral Tube Brush :290mm Long with 150mm bristles up to 35mm diameterSpiral Tube Brush :275m...

4" Engine Cylinder Hone Honing Tools 50-180mm ●Cleans and de-glazes cylinders of carbon deposits quickly and effectively.●Suitable for all cylinder...

Fuel Injector Service ToolSpecial designed for the removal and installation of high pressure injectors with hold down top found in the BMW N20 a...

BMW Flywheel Locking ToolWith Counter Holder / Spacer Sleeves /Reduction Sleeve and Mounting Screws.For locking the flywheel when loosening ortight...

Dual Clutch Transmission Removal Tool For Audi T40217 T40228 ●Used when loosening the side shaft on 6-speed 7-speed 4-wheel drive manual transmissi...

9pc Hook / Pick & Scraper SetMini AwlMini U HookMini L HookMini V Hook175mm Radiator Hose Remover225mm Cotter Pin Puller200mm Scratch Awl225mm ...

Working diameter: 87-89mmShaft diameter: 7.8 mmMax. drive speed: 300 rpm

For repair of defective oxygen sensor threadsReamer Ø 18.6 mm, for reaming of oxygen sensor threadsTap M20 x 1.5, for cutting the repair bushing th...

For loosening and tightening the flywheel and crankshaft pulleySuitable for the following Ford models:Models: Ford C-MAX (2007-2017), S-MAX (2006-2...

This tool is designed for installing and removing sleeves from the cylinder head on the engine.Sleeves need to be replaced when the truck seems pow...

17pc Diesel Injector Seat Cutter SetFor decarbonising injector seats when changing injectors.Helps to avoid blow-back due to poorly seated injector...

Petrol Injector Extractor SetFor BMW N54 / N63 and Mini N14 / N18Designed to remove injectors and re-install the Teflon seals.Applicable : BMW N54 ...

Glow Plug Removal SetFor Removing Damaged or Difficult 8 and 10mmGlow Plugs from the Cylinder Head.

Diesel Engine Head Rebuild Kit - VAG / PorscheJig for fitting camshafts into cylinder heads during head rebuilds.Applicable to VAG and Porsche vehi...

Efficiently and safely install the transmission oil seal for SCANIA transmission flange shafts on both the transmission and rear axle.  Scania Tran...